- Removed some old cruft.
- Removed some support for older versions of automake which technically was
correct, but caused the newer automakes to squawk warnings during an
initial sanity check (which isn't done very intelligently.)
NOTE: this fix is technically not correct for older version of automake.
These older version use the variable "INCLUDES" internally and could have
them already set to an important value. That is why we were appending
our values to them. However, newer versions of automake don't set this
value themselves so it is an error to append to a non-existant variable.
We seem to "get away" with overwriting the value on older versions of
automake, but if you have problems, consider upgrading to at least
automake-1.5.
- automake-1.4 sets default values for INCLUDES which we can't
overwrite.
- automake-1.5 renames this to DEFAULT_INCLUDES and leaves INCLUDES
open for the developer to use.
Thus for automake-1.4 we are forced to 'append' to INCLUDES and in
automake-1.5 we can just set the value to whatever we like.
Unfortunately, the behaviors of the two versions are mutually
incompatible.
The solution I am committing now works for both versions but
automake-1.5 generates a lot of spurious warning messages that are
annoying, but not fatal.
Tony submitted:
JSBsim:
Added trimming routine, it is longitudinal & in-air only at this point
Added support for taking wind & weather data from external source
Added support for flaps.
Added independently settable pitch trim
Added alphamin and max to config file, stall modeling and warning to
follow
c172.cfg:
Flaps!
Adjusted Cmo, model should be speed stable now
FG:
Hooked up Christian's weather code, should be using it soon.
Hooked up the trimming routine. Note that the X-15 will not trim.
This is not a model or trimming routine deficiency, just the
nature of the X-15
The trimming routine sets the pitch trim and and throttle at startup.
The throttle is set using Norman's code for the autothrottle so the
autothrottle is on by default. --notrim will turn it off.
Added --vc, --mach, and --notrim switches
(vc is airspeed in knots)
uBody, vBody, and wBody are still supported, last one entered
on the command line counts, i.e. you can set vc or mach or u,v,
and w but any combination will be ignored.
