Remove the non-functional turn-anticipation code from the GPS, and
enable fly-by mode in (some of the) RNAV controllers: initially the
leg controller.
The new config property is gps/config/enable-fly-by, defaults to off
for compatibility.
Previously, the Nasal files in fgdata/Nasal/*.nas were loaded in
file-name order. This created a particular problem file files
beginning with "a" which might want to use props.nas.
This adds support for an ordered list of files to be defined
in the property tree that will be loaded before the rest of the
Nasal files.
Avoid encoding test-data as strings, since this exceeds MSVC limits
on string literals, and tests don’t need to be relocatable anyway,
so we can just hard-code the source location into config.h
Overhaul how transitions are stored in FlightPlan XML, and how
they’re exposed to Nasal. Simplify the Nasal access by making
‘sid_trans’ and ‘star_trans’ writeable.
Extend the unit-tests a lot to cover this, both from C++ and also
from Nasal
As part of this, overhaul the ownership of FlightPlan delegate
factories, to make it safer (use ref-counting of the factories,
and allow the factory to customise delegate clean-up behaviour)
Make FlightPlan::findIndexOfWp use the correct ::matches() method,
and special case this for basic waypoints. This fixes the behaviour
when loaded routes / procedures store a navaid-waypoint as basic.
Where the plan does not contain departure / arrival WPs, fire the
corresponding delegate methods after load, to run the selection logic.
Also, add a ‘loaded’ delegate callback, to give delegates a chance to
perform validation and fix-up after all flight-plan loads.
Re-work how position-init and ATC-manager work together to do
parking assignment and fallback (when the parking is unavailable).
Improve the logic for the reposition case, and teach ATC-manager about
reposition explicitly.
When the parking is unavailable, explicitly fall back to best-runway
selection in finalizePosition.
Add many additional position-init tests, to cover all of this.
This avoids an issue where the dialog doesn’t update on macOS, if it’s
shown immediately after a native message box, such as the migration
warning dialog.
This was intended to only affect Debug builds, but when using a multi-
config generator (XCode, Visual Studio etc) it affects all builds.
Disabling for now until we figure out a better way to do this.
