Here is the KAP140 Two Axis Autopilot update.
I think it's fairly complete now, all the modes are working. I tested the
localizer and glideslope hold and it was pretty stable all the way down to
the middle marker.
In the pilot guide for backcourse hold (REV) mode it says to reset the heading
bug to the _front course_. I haven't figured out how to implement this so for
the time beeing one should reset the heading bug to the _backcourse_. Apart
from this the panel should operate identical to the way the pilot guide
describes.
Here is the KAP140 Two Axis Autopilot.
Aircraft/Instruments/KAP140TwoAxis.xml
Is of course the instrument config file.
Aircraft/Instruments/Textures/KAP140.rgb
The texture.
Nasal/kap140.nas
Most of the work is done here. Without Nasal I don't see how I could implement
the NAV-ARM modes and the flashing annunciators.
Aircraft/c172p/Systems/KAP140.xml
The autopilot PID controllers configuration file. Maybe this file should be in
a more accessible directory and not hidden deep inside c172p!?
I've also attached the changes to the default C172 to include this autopilot
in the 3d-cockpit panel and the 2d vfr panel. Or at least I hope that I've
managed to include all that is needed.
tanks created by the C++ code look empty, and were causing the fuel
code to detect out of fuel conditions. Since there is no way to tell
a "FDM" tank from a "C++" tank, I just filter them by capacity. Very
ugly hack, we need to fix the code to report only the tanks created
by the aircraft/FDM configuration.
Don't know if this was intentional, but since revision 1.128
(2003/10/01 21:15:55; david; "Add some whitespace, and initialize
the new ADF subsystem.") the ADF isn't initialized with useful
frequencies any more. It should be something in the bay area.
379 is for BRIJJ again (in the glide slope of KSFO) and 341 is
for RORAY (KOAK). Don't know what the standby frequency was before.
Add clickable range selection for the radar and wxradar. Right
now it is clickable only between 20 and 40 mile ranges, which should work for
most uses.
OV10-jsbsim-set.xml has many changes. It creates a thunderstorm over
woodside VOR. It removes the lowest cloud layer so that the storm can be
seen. It sets the surface wind speed to zero, which may help stop the
"drifting left" complaints. It sets the radar range to 40 miles.
The weather radar instrument is corrected.
