Uses these properties:
/sim/atis/speed
/sim/atis/volume
/sim/atis/pitch
Values 1.0 behave as default. Other values are used to multiply default
settings.
Changes don't take affect immediately. But changing com frequency seems to
often cause an update which will then pick up the new values.
Both the route-path cade and the RNAV code were using some bad logic
to compute the intersection point. All fixed now, but requires a
new helper in Simgear.
Remove the non-functional turn-anticipation code from the GPS, and
enable fly-by mode in (some of the) RNAV controllers: initially the
leg controller.
The new config property is gps/config/enable-fly-by, defaults to off
for compatibility.
Similar to enable-velocity-vector, but indicates velocity relative to ground,
rather than velocity relative to air. E.g. useful for crosswind landings.
Ensure changes from Nasal are picked up by delegates (such as GPS) when
they are made. Add a route-manager test which sets and exits a hold
using Nasal.
As part of this, update the test API to make it easy to run Nasal from
a test.
The GPS/RNAV system can now fly holds, both left and right-handed.
The correct entry is selected, and hold count can be selected.
Also there's lots of lovely test cases.
Avoid screwing up the derived / trend data when we are repositioned;
detect instantaneous position changes and don’t update the trend
data in this case.
GPS now lets the delegate handle the sequencing behaviour, by
setting a new config property. The default GPS delegate (in Nasal)
now sets this property.
This requires a corresponding FGData update.
- set wp[1] properties immediately (don’t require an update cycle)
- direct-to course-error is correct when init-ing the Direct-To; it
was previously wrong when beginning the DTO, due to invalid course
between identical SGGeods.
This is a clean up commit prior to the subsystem API standardisation to simplify
the diffs. It includes all SGSubsystem and SGSubsystemGroup derived classes.
Revert this change - I will re-add the unit-tests again, but we need
a different approach for 8.3 stations, than what I did here.
This reverts commit 91cc83abb5.
In 8.3 mode, ensure that 25 and 75Khz channels can be tuned using the
abbreviated syntax (eg 118.02 for 118.025).
As part of this, add test coverage of the CommRadio for basic and 8.3-
mode operation.
- when add-noise is false, mute noise completely
- if the CommRadio is not powered by the generic electrical system,
work by default (as was previously the case)
