8183684930
Here are some more updates, and bits and pieces. The tsr2 is mostly a re-write, with more reasonable figures for the wing and hstab. I've also tried to reduce the poly count on the model whilst adding the airbrakes and canopies. Finally, I've set up some panels, based on the c310 vfr and mini panels. The vfr panels have a lot of additional instruments on them but impose quite a high frame-rate hit on my system. The mini panels also have some additional instruments but seem to work without noticable penalty here. I've set these panels as the defaults for these aircraft but I'm not sure it's a good idea to have the vfr panels by default due to the performance hit. Using them as default will should give some feedback though;) To go with the new panels are a number of rough and ready instruments I hacked, mostly out of one of the rpm gauges, but I've adapted the throttle quadrent (jet-throttle-quadrant) to funstion for throttle, flaps and reheat. All the gauge faces were based on an existing ffgfs instrument texture, so there's no problem with copyright there. All the other bits that I've done may be distributed under the same conditions as fgfs.
133 lines
5.7 KiB
XML
Executable file
133 lines
5.7 KiB
XML
Executable file
<!-- TSR2 yasim config. This is a hack and not an authentic
|
|
representation of the aircraft. Having said that, the
|
|
numbers, where I could find them, roughly match those of
|
|
the original aircraft. Lee Elliott.
|
|
|
|
The ailerons are a hack on this fdm - the real aircraft
|
|
use all moving tail planes for roll and this model had a
|
|
very high roll rate so they've been made relatively
|
|
ineffective and in the model/anim file the aileron surface
|
|
positions actually operate on the tailplanes.
|
|
-->
|
|
|
|
<airplane mass="54750">
|
|
|
|
<!-- Approach configuration -->
|
|
<approach speed="130" aoa="10.0">
|
|
<control-setting axis="/controls/throttle[0]" value="0.2"/>
|
|
<control-setting axis="/controls/throttle[1]" value="0.2"/>
|
|
<control-setting axis="/controls/flaps" value="1.0"/>
|
|
<control-setting axis="/controls/spoiler" value="0.2"/>
|
|
<control-setting axis="/controls/gear-down" value="1"/>
|
|
</approach>
|
|
|
|
<!-- Cruise configuration -->
|
|
<!-- <cruise speed="500" alt="35000"> -->
|
|
<cruise speed="550" alt="35000"> -->
|
|
<control-setting axis="/controls/throttle[0]" value="0.5"/>
|
|
<control-setting axis="/controls/throttle[1]" value="0.5"/>
|
|
<control-setting axis="/controls/flaps" value="0.0"/>
|
|
<control-setting axis="/controls/gear-down" value="0"/>
|
|
</cruise>
|
|
|
|
<cockpit x="8.5" y="0.0" z="1.0"/>
|
|
|
|
<fuselage ax="13.0" ay="0" az="0" bx="-14.13" by="0" bz=".64"
|
|
width="2.0" taper="0.5" midpoint="0.3"/>
|
|
|
|
<wing x="-3.0" y="1.5" z="1.7" taper="0.25"
|
|
length="5.0" chord="6.0" sweep="50" dihedral="-1.0" camber="0.003">
|
|
<stall aoa="35.0" width="3" peak="1.3"/>
|
|
<flap0 start="0.0" end="0.9" lift="1.4" drag="1.2"/>
|
|
<flap1 start="0.0" end="0.4" lift="1.05" drag="1.2"/>
|
|
<spoiler start="0.54" end="0.86" lift="0.0" drag="20.0"/>
|
|
|
|
<control-input axis="/controls/flaps" control="FLAP0"/>
|
|
<control-input axis="/controls/aileron" control="FLAP1" split="true"/>
|
|
<control-input axis="/controls/aileron-trim" control="FLAP1" split="true"/>
|
|
<control-input axis="/controls/spoilers" control="SPOILER"/>
|
|
|
|
<control-output control="FLAP0" prop="/surface-positions/flap-pos-norm"/>
|
|
<control-output control="FLAP1" side="left"
|
|
prop="/surface-positions/left-aileron-pos-norm"/>
|
|
<control-output control="FLAP1" side="right"
|
|
prop="/surface-positions/right-aileron-pos-norm"/>
|
|
<control-output control="SPOILER" side="left"
|
|
prop="/surface-positions/left-spoiler-pos-norm"/>
|
|
<control-output control="SPOILER" side="right"
|
|
prop="/surface-positions/right-spoiler-pos-norm"/>
|
|
|
|
<control-speed control="FLAP0" transition-time="5"/>
|
|
<control-speed control="SPOILER" transition-time="0.5"/>
|
|
|
|
</wing>
|
|
|
|
<hstab x="-10.0" y="1.0" z="0.5" taper=".2" effectiveness="2.0"
|
|
length="3.0" chord="4.0" sweep="55" dihedral="0.0">
|
|
<stall aoa="35.0" width="3" peak="1.5"/>
|
|
<flap0 start="0" end="1" lift="1.26" drag="1.3"/>
|
|
<control-input axis="/controls/elevator" control="FLAP0"/>
|
|
<control-input axis="/controls/elevator-trim" control="FLAP0"/>
|
|
<control-output control="FLAP0" prop="/surface-positions/elevator-pos-norm"/>
|
|
</hstab>
|
|
|
|
<vstab x="-10.0" y="0" z="1.38" taper=".176" effectiveness="1.0"
|
|
length="4.5" chord="4.0" sweep="50">
|
|
<stall aoa="28.0" width="3" peak="1.5"/>
|
|
<flap0 start="0" end="1" lift="1.15" drag="1.3"/>
|
|
<control-input axis="/controls/rudder" control="FLAP0" invert="true"/>
|
|
<control-output control="FLAP0" prop="/surface-positions/rudder-pos-norm"/>
|
|
</vstab>
|
|
|
|
<!-- nose -->
|
|
<gear x="3.0" y="0" z="-2.0" retract-time="7" compression="0.8">
|
|
<control-input axis="/controls/rudder" control="STEER" square="true"/>
|
|
<control-input axis="/controls/gear-down" control="EXTEND"/>
|
|
<control-speed control="EXTEND" transition-time="7"/>
|
|
<control-output control="EXTEND" prop="/gear/gear/position-norm"/>
|
|
</gear>
|
|
|
|
<!-- left main -->
|
|
<gear x="-4.0" y="2.5" z="-2.0" retract-time="7" compression="0.8">
|
|
<control-input axis="/controls/brakes[0]" control="BRAKE"/>
|
|
<control-input axis="/controls/gear-down" control="EXTEND"/>
|
|
<control-speed control="EXTEND" transition-time="7"/>
|
|
<control-output control="EXTEND" prop="/gear/gear[0]/position-norm"/>
|
|
</gear>
|
|
|
|
<!-- right main -->
|
|
<gear x="-4.0" y="-2.5" z="-2.0" retract-time="7" compression="0.8">
|
|
<control-input axis="/controls/brakes[1]" control="BRAKE"/>
|
|
<control-input axis="/controls/gear-down" control="EXTEND"/>
|
|
<control-speed control="EXTEND" transition-time="7"/>
|
|
<control-output control="EXTEND" prop="/gear/gear[1]/position-norm"/>
|
|
</gear>
|
|
|
|
<!-- Canopy -->
|
|
<gear x="3.0" y="0.0" z="0.6" retract-time="7" compression="0.6">
|
|
<control-input axis="/controls/parking-brake" control="EXTEND"/>
|
|
<control-speed control="EXTEND" transition-time="10"/>
|
|
<control-output control="EXTEND" prop="/canopy/position-norm"/>
|
|
</gear>
|
|
|
|
<jet x="-8.0" y="-1.0" z="0.4" mass="4000" thrust="16600" afterburner="30600">
|
|
<!-- <jet x="-22.0" y="-1.0" z=".44" mass="4000" thrust="30600"> -->
|
|
<control-input axis="/controls/throttle[0]" control="THROTTLE"/>
|
|
<control-input axis="/controls/afterburner[0]" control="REHEAT"/>
|
|
</jet>
|
|
|
|
<jet x="-8.0" y="1.0" z="0.4" mass="4000" thrust="16600" afterburner="30600">
|
|
<!-- <jet x="-22.0" y="1.0" z=".44" mass="4000" thrust="30600"> -->
|
|
<control-input axis="/controls/throttle[1]" control="THROTTLE"/>
|
|
<control-input axis="/controls/afterburner[1]" control="REHEAT"/>
|
|
</jet>
|
|
|
|
<tank x="-2.0" y="0.0" z="0.5" jet="true" capacity="13000"/>
|
|
<tank x="-3.0" y="2.5" z="1.7" jet="true" capacity="11000"/>
|
|
<tank x="-3.0" y="-2.5" z="1.7" jet="true" capacity="11000"/>
|
|
|
|
<ballast x="8.5" y="0" z="0" mass="3000"/> <!-- Cockpit -->
|
|
<ballast x="4.0" y="0" z="0" mass="3000"/> <!-- avionics -->
|
|
<ballast x="-6.0" y="0" z="0" mass="100"/> <!-- Trim ballast -->
|
|
|
|
</airplane>
|