233 lines
8.2 KiB
Text
233 lines
8.2 KiB
Text
PIPER J3 CUB PERFORMANCE DATA
|
||
=============================
|
||
|
||
[This information is copied from the 1946 J3C-65 owner's handbook.]
|
||
|
||
FLYING HINTS
|
||
|
||
The Piper Cub Special represents more than 15 years of diligent
|
||
aircraft engineering and manufacturing experience. Its simplicity of
|
||
design and construction, its low operating and maintenance costs, its
|
||
inherent stability, ruggedness, and its outstanding safety and ease of
|
||
flying, have made it the most popular airplane in aviation history.
|
||
The Piper Cub Special is the time-tested product of millions of hours
|
||
of flying under all conceivable conditions both in the military and in
|
||
peace time.
|
||
|
||
There are hints on starting, flying, stopping, and other related
|
||
topics that are important to the owner who wants to conserve his
|
||
airplane -- keep it in maximum airworthy condition -- and enjoy a full
|
||
measure of flying satisfaction.
|
||
|
||
|
||
First, each pilot should become familiar enough with his Piper Cub
|
||
Special that he can accomplish a satisfactory pre-flight inspection.
|
||
This check is simple and requires only a few minutes. See Section IX
|
||
for check list. Daily check of airplane prior to flight should be the
|
||
first in a number of safe flying habits the pilot should acquire.
|
||
|
||
|
||
A. BEFORE STARTING ENGINE
|
||
|
||
(1) Make routine check of gasoline supply. Visible fuel gauge is
|
||
integral part of gas tank cap; it will not show number of gallons but
|
||
will show proportion of fuel in tank by length of rod which extends
|
||
upward from cap. A full tank of 12 U.S. gallons will be indicated by
|
||
11 inches of rod extending beyond cap. Keep gas gauge rod clean and
|
||
smooth with crocus cloth for accuracy and freedom of movement.
|
||
|
||
(2) Check oil level in engine sump by removing oil cap and gauge. Oil
|
||
stick should indicate oil level up to index mark of 4 quarts.
|
||
|
||
(3) Check freedom of movement of flight and engine controls.
|
||
|
||
|
||
B. STARTING ENGINE
|
||
|
||
(1) Chock wheels, or have occupant who is familiar with controls set
|
||
brakes in cabin.
|
||
|
||
(2) Ignition switch OFF. Verify.
|
||
|
||
(3) Set throttle approximately 1/10 open.
|
||
|
||
(4) Push fuel shut-off ON.
|
||
|
||
(5) Turn propeller through several times.
|
||
|
||
(6) Turn ignition switch ON.
|
||
|
||
(7) Start engine by pulling propeller through with a snap.
|
||
|
||
CAUTION -- Always handle propeller as if switch were "ON." Stand as
|
||
far in front of propeller as possible. Use both hands and grasp one
|
||
blad approximately midway from tip. Do not overgrasp blade. Do not
|
||
wear long, loose clothing. Make sure footing is sure to preclude
|
||
possibility of feet slipping.
|
||
|
||
(8) If engine does not start, turn switch OFF. Turn primer knob to
|
||
unlock, pull out, pump three or four times, then reseat primer and
|
||
lock by turning in opposite direction. In extremely cold weather a
|
||
few strokes of the primer as the engine starts will enable it to keep
|
||
running. NOTE -- Avoid excessive priming as it causes raw gasoline to
|
||
wash lubricating oil from engine cylinder walls. Do not prime warm
|
||
engine.
|
||
|
||
(9) Repeat starting procedures 6, 7.
|
||
|
||
(10) If engine loads up and refuses to start, turn ignition switch
|
||
"OFF,", open throttle wide and turn propeller through backwards
|
||
several times to unload excessive gas mixture in cylinders. Then
|
||
close throttle and repeat starting procedure.
|
||
|
||
|
||
C. ENGINE WARM-UP
|
||
|
||
(1) As soon as engine starts, advance throttle slightly to idle at 700
|
||
R.P.M. Check engine instruments. If oil pressure gauge does not
|
||
indicate pressure within 30 seconds, stop engine immediately, check
|
||
and correct trouble before any further operation. Oil temperature
|
||
during operating should not rise above 200<30> F. and oil pressure should
|
||
not fall below 30 pounds. With engine warm, idling speed should be
|
||
550-600 R.P.M.
|
||
|
||
(2) Rev engine up to 2100 R.P.M. on both magnetos. Switch to LEFT and
|
||
RIGHT magnetos. R.P.M. drop should not be over 75 R.P.M. CAUTION
|
||
--Do not operate engine on either single magneto for more than 30
|
||
seconds at a time, as this tends to foul the non-operating spark plugs
|
||
in the ignition circuit of the magneto that is switched off.
|
||
|
||
|
||
D. STOPPING ENGINE
|
||
|
||
(1) Never cut switch immediately after landing as this causes engine
|
||
to cool too rapidly.
|
||
|
||
(2) Idle engine, especially in high temperature operating conditions,
|
||
for several minutes. It is advisable to switch to each magneto for 30
|
||
second intervals to allow gradual cooling of engine. This helps to
|
||
prevent overheating of spark plug insulators and will lessen tendency
|
||
for "after-firing."
|
||
|
||
(3) Check for carburetor heat OFF during idling.
|
||
|
||
|
||
E. TAXIING
|
||
|
||
(1) Open throttle to start airplane in motion; then close throttle to
|
||
a setting sufficient to keep airplane rolling. Do not keep throttle
|
||
advanced so that it is necessary to control taxi speed of airplane
|
||
with brakes. This causes unnecessary wear and tear on brakes and
|
||
tires.
|
||
|
||
(2) Taxi slowly (speed of a fast walk) controlling direction with
|
||
rudder which is connected to a steerable tail wheel. Use brakes only
|
||
for positive, precision ground control when necessary.
|
||
|
||
(3) Taxi upwind with stick back; downwind with stick foreward. When
|
||
ground winds are in excess of 15 M.P.H., turn into wind using ailerons
|
||
in direction of turn; apply ailerons away from the turn when turning
|
||
downwind. This procedure helps to prevent the wind "picking up" a
|
||
wing during windy, gusty conditions. Always make ground turns slowly.
|
||
|
||
|
||
F. GENERAL FLYING
|
||
|
||
(1) For takeoff use full throttle, heading into wind. Airplane loaded
|
||
will become airborne at approximately 39 M.P.H. Best climb speed is
|
||
an indicated 55 M.P.H.
|
||
|
||
(2) Indicated R.P.M. for cruising speed of 73 M.P.H. is 2150.
|
||
Take-off R.P.M. is 2300. Do not fly at full throttle over 3 minutes.
|
||
|
||
(3) Use CARBURETOR AIR HEAT when engine runs "rough" and tachometer
|
||
shows drop in R.P.M. which may be due to ice forming in carburetor.
|
||
Tachometer should recover to within 50 R.P.M. below normal when using
|
||
carburetor heat. Push heater to "OFF" position, and if icing
|
||
condition has been cleared, R.P.M. should return to normal. Continued
|
||
use of carburetor heat will only cause increased fuel consumption and
|
||
loss of power.
|
||
|
||
(4) Maximum permissible diving speed is 122 M.P.H.
|
||
|
||
|
||
G. APPROACH AND LANDING
|
||
|
||
(1) Push carburetor heat ON prior to throttling back for glide, or for
|
||
any other flight maneuver.
|
||
|
||
(2) Glide between 50-60 M.P.H. depending upon loading of airplane and
|
||
gust conditions.
|
||
|
||
NOTE -- "Clear" engine by opening throttle gently, every 200-250 feet
|
||
of descent during a long glide so that engine temperature will be
|
||
maintained.
|
||
|
||
Throttle action on the part of the pilot should be smooth and gentle
|
||
at all times.
|
||
|
||
|
||
H. PARKING AND MOORING
|
||
|
||
(1) After termination of flight, enter flying time in aircraft and
|
||
engine log books.
|
||
|
||
(2) Turn ignition and fuel OFF.
|
||
|
||
(3) Chcok the wheels of airplane.
|
||
|
||
(4) If airplane is not to be flown for some time, it should be
|
||
hangared or tied down. Use good quality 1/2" - 5/8" diameter rope.
|
||
Secure to lift assist handle at aft end of fuselage; also at upper end
|
||
of both front wing lift struts where they attach to wing. Make sure
|
||
that rope passes between aileron cable and lift strut. Mooring ropes,
|
||
when airplane is tied down, should have no slack.
|
||
|
||
(5) Lock aileron and elevator controls by wrapping front seat belt
|
||
completely around rear control stick, tighten and buckle.
|
||
|
||
(6) Under excessively wind conditions, airplane should be tailed into
|
||
wind for mooring.
|
||
|
||
|
||
|
||
|
||
[Here is my older information.]
|
||
|
||
These are the only numbers I could find. They are for a J3 Cub with
|
||
an 85HP engine rather than 65 hp, so some adjustments may be
|
||
necessary. The source is
|
||
|
||
http://www.evergreenfs.com/planedata.htm
|
||
|
||
|
||
Speeds
|
||
------
|
||
Best rate of climb (Vy): 65 mph (57 kt)
|
||
Best angle of climb (Vx): 55 mph (48 kt)
|
||
Cruise: 70 mph (61 kt)
|
||
Never-exceed (Vne): 122 mph (106 kt)
|
||
Best Glide (Vglide): 60 mph (52 kt)
|
||
Stall (Vs): 38 mph (33 kt)
|
||
Maneuvering (Va): 70 mph (61 kt)
|
||
Approach: 50-60 mph (44-52 kt)
|
||
|
||
Power
|
||
-----
|
||
Take off: full
|
||
Climb: 50 rpm below full
|
||
Cruise: 2300 rpm
|
||
Approach: 1200 rpm
|
||
Practice stalls: 1200 rpm
|
||
|
||
Distances
|
||
---------
|
||
Take-off: 450-800 ft
|
||
Landing: 200-800 ft
|
||
|
||
Fuel
|
||
----
|
||
Total fuel: 12 gal US
|
||
Usable fuel: 12 gal US
|
||
Grade: 80/87
|
||
GPH: 5 gal US/hr
|